Top Ideas For Concrete Polishing
One of the industries that have undergone great evolution is the polishing industry. This industry has many companies that have grown and others starting now. Still other companies will start as most people are getting into this industry. Quality concrete polishing can be done with the companies that apply the tips contained in this article. These tips are explained in this article.
Determining the surface hardness is the first thing that should be done. This is done by testing its hardness using a concrete hardness tester. This is to help in deciding on the right abrasives. The surface then is scratched with the use of the tip number nine. Then the scratching is done in a descending order. This is done until the tip cannot do the scratching anymore. At this level, the hardness is ok now.
Then the concrete surface is then prepared. Some floors for concrete polishing are coated. Here, the coat is removed with the right equipment. The equipment for removing the coating varies with the type of coating. Some floors may be damaged. The repairing of this holes and cracks should be done first. The next thing that should be done is gritting with the metal bond tooling to the level and flatness that is desired.
Then the metal tool marks have to be removed. This is done through the use of transitional tooling. The transitional tools have the ability to get all the metal tool marks effective. All the tool marks have to disappear for the tool mark removal process to be considered successful.
Then the floor is densified and hardened by vacuuming it. The floor is densified and solidified by the pore and crack filler. It also helps in protecting the floor from water penetration and creation of stains. The pooling of the floor can result hence care should be taken to prevent it from happening. This is because pooling leads to permanent stains that can make polishing hard.
Then now the polishing is done after all the above things are complete. The best thing to start with when polishing is done is reign band tooling. Then dust removal is done between the passes. Then with a burnishing pad, the floor is burnished when the final grit level is reached.
Then the last thing that should be done to the floor is protecting it. The floor is sealed so as it can be protected. This will protect the surface from things like grease, oil, and any other chemicals. The pump can be used to apply the sealer to the floor. The floor can be left shining after burnishing is done. These are the best ideas that can allow successful concrete polishing.